"Apply a small amount evenly to the back of the LED and the star. Solder the star on promptly and apply pressure while the epoxy sets (the thinner the layer is the better it works)."
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Fri 24/Jul/09 12:15am
Views: 589
Posted by: znomit
Posted in: Building L E D Night Lights
Posted on: Sat 23/Apr/11 10:20pm
Views: 755
"Clear up the star and the LED - note the terminals and pads have been cleaned up:"
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Fri 24/Jul/09 12:14am
Views: 491
Posted by: plummet
Posted in: Building L E D Night Lights
Posted on: Wed 9/Jul/08 9:32pm
Views: 1,056
Posted by: plummet
Posted in: Building L E D Night Lights
Posted on: Wed 9/Jul/08 9:26pm
Views: 1,046
"That sucker is 0.1 Ohms hence the R100. Sorry about the crap photography [corrected typo with the resistor value]:"
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Fri 24/Jul/09 12:16am
Views: 477
Posted by: Tojja
Posted in: Building L E D Night Lights
Posted on: Wed 28/Feb/07 1:55pm
Views: 7,110
"High-Low-High etc switch on left of helmet."
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Sun 10/Oct/10 8:19pm
Views: 676
Posted by: Datsane
Posted in: Building L E D Night Lights
Posted on: Fri 2/May/08 12:01pm
Views: 1,731
"Quad Mic Cable"
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Mon 11/Oct/10 6:39pm
Views: 584
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Sun 9/Oct/11 9:27pm
Views: 648
Posted by: ryda
Posted in: Review - Cheap Dx.com Lights For Night Riding.