Building L E D Night Lights Images

Posted by: ryda

Posted in: Building L E D Night Lights

Posted on: Tue 11/Mar/08 10:17am

Views: 1,263

"After resoldering the LED wires carefully press the brass PCB retainer into the body - polygrips are ideal:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:19am

Views: 768

"No snaging on low branches"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Sun 10/Oct/10 8:12pm

Views: 673

Posted by: plummet

Posted in: Building L E D Night Lights

Posted on: Sat 2/Aug/08 10:38pm

Views: 1,540

"Apply Arctic Silver 5 (pretty much the best available) heatsink goo onto the faces between the star and the body. Tighten the screws. Now we need to remove resistor R04 because it is somewhat under-rated for the ~0.4 Watts it needs to dissipate inside a hot body... It is shown here:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:15am

Views: 808

Posted by: nibbler

Posted in: Building L E D Night Lights

Posted on: Mon 19/Mar/07 2:46pm

Views: 984

Posted by: Datsane

Posted in: Building L E D Night Lights

Posted on: Fri 2/May/08 12:01pm

Views: 1,775

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Tue 11/Oct/11 8:22am

Views: 803

Posted by: tombomb600

Posted in: Building L E D Night Lights

Posted on: Tue 22/Apr/08 7:42pm

Views: 1,428

"CHECK THAT THE TORCH ACTUALLY WORKS NOW (much too hard to fix with goo everywhere) Apply Arctic Silver 5 this time to the lip between the light's body and the LED carrier:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:19am

Views: 529

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Sun 9/Oct/11 9:28pm

Views: 894

Posted by: Flash

Posted in: Building L E D Night Lights

Posted on: Fri 27/Jun/08 1:16pm

Views: 1,298