Building L E D Night Lights Images

More Images
Latest Night Riding Images

Posted by: Datsane

Posted in: Building L E D Night Lights

Posted on: Fri 2/May/08 12:01pm

Views: 1,861

Posted by: plummet

Posted in: Building L E D Night Lights

Posted on: Wed 9/Jul/08 9:32pm

Views: 1,157

"Apply Arctic Silver 5 (pretty much the best available) heatsink goo onto the faces between the star and the body. Tighten the screws. Now we need to remove resistor R04 because it is somewhat under-rated for the ~0.4 Watts it needs to dissipate inside a hot body... It is shown here:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:15am

Views: 810

"In they go. Take care that they are not too close to the metal rim and don't apply too much force on the pads. Check the soldering with a magnifier of some sort:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:18am

Views: 662

Posted by: Flash

Posted in: Building L E D Night Lights

Posted on: Fri 27/Jun/08 1:15pm

Views: 1,382

Posted by: Flash

Posted in: Building L E D Night Lights

Posted on: Fri 27/Jun/08 1:16pm

Views: 1,300

Posted by: Datsane

Posted in: Building L E D Night Lights

Posted on: Thu 19/Jul/07 9:24pm

Views: 1,452

Posted by: znomit

Posted in: Building L E D Night Lights

Posted on: Sat 23/Apr/11 10:20pm

Views: 879

Posted by: Tojja

Posted in: Building L E D Night Lights

Posted on: Wed 28/Feb/07 1:55pm

Views: 7,206

"Then screw the reflector and lens back on and you are done:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:22am

Views: 530

"Apply a small amount evenly to the back of the LED and the star. Solder the star on promptly and apply pressure while the epoxy sets (the thinner the layer is the better it works)."

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:15am

Views: 694