Building L E D Night Lights Images

More Images
Latest Night Riding Images

"Remove the handlebar bracket:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:08am

Views: 419

"EC5 Connector and Dimmer switch wire"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Mon 11/Oct/10 6:40pm

Views: 544

"Mix up AAA heatsink epoxy 1:1 ratio:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:14am

Views: 422

Posted by: slidecontrol

Posted in: Building L E D Night Lights

Posted on: Fri 13/Jun/08 10:44pm

Views: 1,133

"Apply a small amount evenly to the back of the LED and the star. Solder the star on promptly and apply pressure while the epoxy sets (the thinner the layer is the better it works)."

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:15am

Views: 521

"Reassemble the retaining ring with Arctic Silver 5. Note the goo coming out of the hole:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:21am

Views: 442

"Remove some of the solder on the led terminals and lift the LED from its star (with solder hot):"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:11am

Views: 626

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Tue 11/Oct/11 8:22am

Views: 595

"CHECK THAT THE TORCH ACTUALLY WORKS NOW (much too hard to fix with goo everywhere) Apply Arctic Silver 5 this time to the lip between the light's body and the LED carrier:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:19am

Views: 393

Posted by: CleverNickName

Posted in: Building L E D Night Lights

Posted on: Sun 3/Aug/08 9:52am

Views: 1,302

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Sun 9/Oct/11 9:27pm

Views: 545

"Apply Arctic Silver 5 (pretty much the best available) heatsink goo onto the faces between the star and the body. Tighten the screws. Now we need to remove resistor R04 because it is somewhat under-rated for the ~0.4 Watts it needs to dissipate inside a hot body... It is shown here:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:15am

Views: 630