Building L E D Night Lights Images

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Tue 11/Oct/11 8:22am

Views: 725

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Sun 9/Oct/11 9:26pm

Views: 721

Posted by: Datsane

Posted in: Building L E D Night Lights

Posted on: Fri 2/May/08 12:01pm

Views: 1,739

Posted by: Flash

Posted in: Building L E D Night Lights

Posted on: Fri 27/Jun/08 1:15pm

Views: 1,286

"User interface is sweet...."

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Sun 10/Oct/10 8:59pm

Views: 640

Posted by: speeding_ant

Posted in: Building L E D Night Lights

Posted on: Tue 7/Jul/09 12:55pm

Views: 346

Posted by: ryda

Posted in: Building L E D Night Lights

Posted on: Tue 11/Mar/08 10:17am

Views: 1,162

"Heat sink good between the star and the body - that is new...: This has to be cleaned off."

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:12am

Views: 583

"Cateye Opticube"

Posted by: avantibill

Posted in: Building L E D Night Lights

Posted on: Sun 25/May/08 7:31pm

Views: 1,461

"Two 0.6Watt 0.2 Ohm resistors in parallel are my choice… Remember it will be hot in there (crap photography again) [corrected value typo here too]:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:17am

Views: 444

"Apply Arctic Silver 5 (pretty much the best available) heatsink goo onto the faces between the star and the body. Tighten the screws. Now we need to remove resistor R04 because it is somewhat under-rated for the ~0.4 Watts it needs to dissipate inside a hot body... It is shown here:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:15am

Views: 707

"This is where we need to do something better:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:16am

Views: 617