Building L E D Night Lights Images

"High-Low-High etc switch on left of helmet."

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Sun 10/Oct/10 8:19pm

Views: 557

Posted by: znomit

Posted in: Building L E D Night Lights

Posted on: Sat 23/Apr/11 10:20pm

Views: 596

"Using a large screwdriver carefully prise the brass PCB carrier out of the main body - don't mangle or munt the wiring or the torroidal inductor though:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:10am

Views: 435

Posted by: tombomb600

Posted in: Building L E D Night Lights

Posted on: Tue 22/Apr/08 7:44pm

Views: 1,291

"Two 0.6Watt 0.2 Ohm resistors in parallel are my choice… Remember it will be hot in there (crap photography again) [corrected value typo here too]:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:17am

Views: 327

Posted by: Datsane

Posted in: Building L E D Night Lights

Posted on: Fri 2/May/08 12:01pm

Views: 1,632

"EC5 Connector and Dimmer switch wire"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Mon 11/Oct/10 6:40pm

Views: 475

Posted by: cd

Posted in: Building L E D Night Lights

Posted on: Mon 21/Apr/08 2:13pm

Views: 1,436

"Apply Arctic Silver 5 (pretty much the best available) heatsink goo onto the faces between the star and the body. Tighten the screws. Now we need to remove resistor R04 because it is somewhat under-rated for the ~0.4 Watts it needs to dissipate inside a hot body... It is shown here:"

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Fri 24/Jul/09 12:15am

Views: 594

Posted by: znomit

Posted in: Building L E D Night Lights

Posted on: Sat 18/Oct/08 10:46pm

Views: 559

Posted by: VERT

Posted in: Building L E D Night Lights

Posted on: Mon 14/Apr/08 10:35pm

Views: 945

"Battery on the back."

Posted by: mark2c

Posted in: Building L E D Night Lights

Posted on: Sun 10/Oct/10 8:19pm

Views: 602