"P4 next to P7 (compliments to HgRyu for the photo)"
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Tue 18/Mar/08 7:12pm
Views: 2,321
"Remove the LED wires:"
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Fri 24/Jul/09 12:11am
Views: 822
"Mix up AAA heatsink epoxy 1:1 ratio:"
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Fri 24/Jul/09 12:14am
Views: 621
Posted by: Flash
Posted in: Building L E D Night Lights
Posted on: Fri 27/Jun/08 1:17pm
Views: 1,491
Posted by: Fraser
Posted in: Building L E D Night Lights
Posted on: Sat 27/Mar/10 7:43am
Views: 548
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Sun 9/Oct/11 9:26pm
Views: 853
"Remove the handlebar bracket:"
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Fri 24/Jul/09 12:08am
Views: 721
"Needs shorter cable"
Posted by: VERT
Posted in: Building L E D Night Lights
Posted on: Thu 19/Jul/07 9:05pm
Views: 1,586
"New too is the presence of heatsink goo between the LED and the star:"
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Fri 24/Jul/09 12:13am
Views: 699
Posted by: plummet
Posted in: Building L E D Night Lights
Posted on: Wed 9/Jul/08 9:24pm
Views: 1,180
"Apply Arctic Silver 5 (pretty much the best available) heatsink goo onto the faces between the star and the body. Tighten the screws.
Now we need to remove resistor R04 because it is somewhat under-rated for the ~0.4 Watts it needs to dissipate inside a hot body... It is shown here:"
Posted by: mark2c
Posted in: Building L E D Night Lights
Posted on: Fri 24/Jul/09 12:15am
Views: 883
Posted by: ryda
Posted in: Building L E D Night Lights
Posted on: Tue 11/Mar/08 10:17am
Views: 1,341
Posted by: ryda
Posted in: Review - Cheap Dx.com Lights For Night Riding.